Multitech MultiConnect Adapter Podręcznik Użytkownika Pobierz pdf (Strona 80)

Chapter 6 – Serial-to-Network Connectivity Using Serial Dial-in

Command Line Interface and Application Examples for Multi-Tech Systems, Inc. IP Modules (S000368F) 80

Scenario 3 – Auto Dial-in Session in RAW

Mode

This scenario shows how to configure an auto dial-in session in RAW mode.

Prerequisites

RAW mode (Global and each port) MUST BE ENABLED using the following command:

Enable/Disable the RAW mode globally for all Auto-Dial-in sessions: # set ip telnet raw-mode <enable/disable>

The auto dial-in session is opened by Telnet client (embedded in the IP module) in RAW-mode to the configured

server on a configured port number. Once the session is opened successfully, there can be two-way traffic between

the serial device and the remote server.

Important – You cannot switch between the Command Prompt and a Dial-in session in RAW-mode.

Auto Dial-in Feature in RAW Mode

Wireless IP Auto Dial-In in RAW Mode Setup Commands

# set ip telnet raw-mode enable

# set serial auto-telnet enable

# set serial s0 auto-dialin enable

# set serial s0 raw-dialin enable

# set serial s0 auto-dialin trig-mode dtr-char

# set serial s0 auto-dialin-host <202.54.39.96>

# set serial s0 auto-dialin-port 5000

# set serial s0 auto-dialin-protocol telnet

# set serial s0 stop-bits 1

# set serial s0 baud-rate 115200

# set serial s0 data-bits 8

# set serial s0 parity none

# set serial s0 flow-control rts-cts

# set serial s1 stop-bits 1

# set serial s1 baud-rate 115200

# set serial s1 data-bits 8

# set serial s1 parity none

# set serial s1 flow-control rts-cts

# set serial s1 connect-type modem

# set serial s1 modem dial-number 123

# set serial s1 modem dialing-trig-mode none (See Chapter 4 - Scenario Setup Prerequisites)

# set ppp ppp0 ipcp-mode client-only

# set ppp ppp0 username "IP module"

# set ppp ppp0 password "IP module"

# save

Notes

• Once the PPP link is up with an IP address, auto dial-in session can be probed as in the above scenario.

• You cannot open more than one Dial-in session.

• You cannot switch between the Command Prompt and a Dial-in session in RAW mode.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 153 154

Komentarze do niniejszej Instrukcji

Brak uwag

Multitech MultiConnect Adapter Podręcznik Użytkownika Strona 80

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Networking Multitech MultiConnect Adapter