Multitech MA3a Podręcznik Użytkownika Pobierz pdf (Strona 22)

MultiArray User Guide

Installing a Disk Drive into Horizontal Chassis

Your MA3a comes pre-configured with a floppy and CD-ROM drive installed in the combination

horizontal drive chassis. The data and power cables from these drives have already been

connected. If you wish to add a disk drive, proceed with the following procedure.

1 Remove the two top front combination horizontal chassis mounting screws. See Figure

2-12.

2 Loosen, but do not remove, the two top rear chassis mounting screws. See Figure 2-12.

3 Slide the chassis out the front of the MultiArray to the end of the slide travel.

Front Drive Chassis

Mounting Screw

Rear Drive Chassis

Mounting Screw

Figure 2-12. Combination Horizontal Chassis Mounting Screws

4 Remove the ribbon (data) and power cables from the installed disk drives.

5 Remove the two rear chassis mounting screws and slide the chassis out the front of the

MultiArray.

Horizontal Drive

Chassis

CD-ROM

Floppy Disk

Drive

Drive Mounting

Screws (4 per device)

Chassis Mounting

Screws (4)

Figure 2-13. Combination Horizontal Chassis

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Brak uwag

Multitech MA3a Podręcznik Użytkownika Strona 22