Multitech MTCMR-E1 Instrukcja Użytkownika Pobierz pdf (Strona 17)

Part 1 – AT Commands for All Universal IP Devices

Universal IP AT Commands Reference Guide 17

#VVERSION – Display Software Version

Description: This command directs the TCP/IP stack to display the software version.

Syntax: AT#VVERSION

Values: No TCP/IP parameters.

#VSTATE – Display Current State of Physical Connection

Description: This command displays the status of the physical network connection.

This command is for all devices except the SocketWireless Wi-Fi (MT810SWM-IP).

Syntax: AT#VSTATE

Responses: #STATE: "IDLE" Physical connection is idle and ready to connect

#STATE: "DIALING" Physical connection is attempting to contact the network

#STATE: "AUTHENTICATING" Physical connection is complete; PPP authentication is being

performed

#STATE: "CONNECTED" Physical connection is complete and PPP negotiation is complete;

stack is ready for client commands

#STATE: "DISCONNECTING" Physical connection is in the process of disconnecting from the

network

#STATE: "DISCONNECTED" Physical connection is disconnected from the network (Only used

on the MT100SEM-IP)

#STATE: "CHECKING" Checking current status; try again

#VALL – Display All Parameters

Description: The MT100SEM display of Possible Responses differs slightly from the MT5692SMI-IP display. An

example of the MT100SEM Possible Responses screen is included on this page. See the next

page for an example of the other Possible Responses screen.

This command directs the TCP/IP stack to display all AT# parameters. The parameters are

displayed by blocks of categories separated by a <CR><LF> sequence, all at the same time.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 118 119

Brak uwag

Multitech MTCMR-E1 Instrukcja Użytkownika Strona 17