
29
MA6
4 Being careful to maintain slack in the power cables, lift the card cage up and over so
that it can rest along side the chassis.
5 Remove the screw(s) that secures the ISI board(s) to the chasis at the back of the
MiniArray
III
.
6 Remove the ISI board(s) from the midplane.
7 To replace the ISI board(s), verify ISI board configuration; refer to the Installation
Instructions in the ISI section of this manual.
8 Install the new ISI card(s) by following steps 1-6 in reverse.
Hard Disk Drive Removal/Replacement
Table 4.4 Hard Drive Removal/Replacement Procedure
Step Procedure
1 Remove the MiniArray
III
from rack enclosure following the procedures in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. See figure 4-3.
Note
If you are simply adding a hard drive and not replacing the
existing hard drive, proceed to step 6.
3 Disconnect the power and data cables from the back of the hard disk drive.
4 Remove the two screws securing the hard drive to the drive chassis.
5 Remove hard drive by sliding it off of the drive chassis, towards the back of the unit.
6 To install a new hard drive, follow steps 1-5 in reverse.
Floppy Disk Drive Removal/Replacement
Table 4.5 Floppy Drive Removal/Replacement Procedure
Step Procedure
1 Remove the MiniArray
III
from rack enclosure following the steps in Table 4.1.
2 Remove the top cover from the MiniArray
III
by removing the seven cover mounting
screws located in the back of the MiniArray
III
. See figure 4-3.
3 Remove the chassis mounting screw from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage, including fan
housing, up and over so that it can rest along side the chassis.
Komentarze do niniejszej Instrukcji