Multitech MTCBA-C-U-N2 Dokumentacja Pobierz pdf (Strona 101)

Chapter 7 – Call-Related Commands

Multi-Tech Systems, Inc. AT Commands for EDGE (E1) Modems (S000474A) 101

7.16 ATS8 Set Number of Seconds to Wait for Comma

Dialing Modifier

Description: No effect for GSM. This command specifies the amount of time, in seconds, that the DCE

shall pause, during signaling of call addressing information to the network (dialing), when

a “,” (comma) dial modifier is encountered in a dial string.

Syntax: Read Command: ATS8?

Response: <n>

Write Command: ATS8=<n>

Response: OK

ERROR

Parameter:

<n> This value can be stored with AT&W and can be displayed with AT&V.

0 DCE does not pause when “,” encountered in dial string. Default. (This is the factory default value

and can be restored to '0' with AT&F).

1...255 Number of seconds to pause

Notes:

• This command is not PIN protected.

• This command is supported in airplane mode.

7.17 ATS10 Set Disconnect Delay after Indicating the

Absence of Data Carrier

Description: This parameter setting determines the amount of time that the TA remains connected in

absence of a data carrier.

If the data carrier is detected before disconnect, the TA remains connected.

Syntax: Read Command: ATS10?

Response: <n>

Write Command: ATS10=<n>

Response: OK

ERROR

Parameter Description:

<n> This value can be stored with AT&W and can be displayed with AT&V.

Number of tenths of seconds of delay

001 - 254 Default is 2 (This is the factory default value and can be restored to '2' with AT&F).

Notes:

• This command is not PIN protected.

• This command is supported in airplane mode.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 307 308

Brak uwag

Multitech MTCBA-C-U-N2 Dokumentacja Strona 101