Multitech MT5634ZBA Podręcznik Użytkownika

MT5634ZBA-DIDData/Fax/DID ModemUser Guide

Chapter 3 - Operation10MultiModemDID User GuideChapter 3 – OperationFront Panel of the MultiModemDID ModemThe MT5634ZBA-DID modem has 10 LED indicator

Chapter 3 - Operation11MultiModemDID User GuideDID OperationDirect Inward Dialing (DID) uses an analog trunk line to route several phone numbers to on

Chapter 3 - Operation12MultiModemDID User GuideConnecting to the InternetYour Multi-Tech modem is your gateway to the Internet and the World Wide Web.

Chapter 4 - AT Commands, S-Registers, Result Codes13MultiModemDID User GuideChapter 4 - AT Commands, S -Registers,and Result CodesAT commands are used

Chapter 4 - AT Commands, S-Registers, Result Codes14MultiModemDID User GuideAT CommandsCommand: AT Attention CodeValues: n/aDescription: The attention

Chapter 4 - AT Commands, S-Registers, Result Codes15MultiModemDID User Guide@ Wait for quiet answer. Causes modem to wait for a ringback, then 5 secon

Chapter 4 - AT Commands, S-Registers, Result Codes16MultiModemDID User GuideCommand: MnMonitor Speaker ModeValues:n = 0, 1, 2, or 3Default: 1Descripti

Chapter 4 - AT Commands, S-Registers, Result Codes17MultiModemDID User GuideCommand: T Tone DialingValues: P, TDefault: TDescription: Configures the m

Chapter 4 - AT Commands, S-Registers, Result Codes18MultiModemDID User GuideCommand: &DnData Terminal Ready (DTR) ControlValues:n = 0, 1, 2, or 3D

Chapter 4 - AT Commands, S-Registers, Result Codes19MultiModemDID User GuideCommand: &SnData Set Ready (DSR) ControlValues:n = 0 or 1Default: 0Des

User GuideProduct Number S000234A Revision AMultiModemDID (MT5634ZBA-DID)CopyrightCopyright © 2002 by Multi-Tech Systems, Inc.All rights reserved. Thi

Chapter 4 - AT Commands, S-Registers, Result Codes20MultiModemDID User GuideCommand: \BnTransmit BreakValues:n = 0–9 in 100 ms unitsDefault: 3Descript

Chapter 4 - AT Commands, S-Registers, Result Codes21MultiModemDID User GuideCommand: \NnError Correction Mode SelectionValues:n = 0–5, or 7Default: 3D

Chapter 4 - AT Commands, S-Registers, Result Codes22MultiModemDID User GuideCommand: %A Adaptive Answer Result Code EnableValues:n = 0 or 1Default: 0D

Chapter 4 - AT Commands, S-Registers, Result Codes23MultiModemDID User GuideCommand: %RnCisco ConfigurationValues:n = 0, 1Default: 0Description: %R0 D

Chapter 4 - AT Commands, S-Registers, Result Codes24MultiModemDID User GuideCommand: +DR=nV.44 Data Compression ReportingValues:n = 0 or 1Default: 0De

Chapter 4 - AT Commands, S-Registers, Result Codes25MultiModemDID User GuideSubparametersdirectionSpecifies the DTE direction of the data compression.

Chapter 4 - AT Commands, S-Registers, Result Codes26MultiModemDID User GuideCommand: +MS= Modulation SelectionValues: See description.Defaults: See de

Chapter 4 - AT Commands, S-Registers, Result Codes27MultiModemDID User GuideautomodeAn optional numeric value that enables or disables automaticmodula

Chapter 4 - AT Commands, S-Registers, Result Codes28MultiModemDID User GuideV.92 CommandsCommand: +PCW=nCall Waiting EnableValues:n = 0, 1, or 2Defaul

Chapter 4 - AT Commands, S-Registers, Result Codes29MultiModemDID User GuideCommand: +PMHR=nModem on Hold InitiateValues:n = 0–13Default: 0Description

Contents3MultiModemDID User GuideTable of ContentsChapter 1 - Introduction and Description...

Chapter 4 - AT Commands, S-Registers, Result Codes30MultiModemDID User GuideCommand: +PQC=nQuick Connect ControlValues:n = 0, 1, 2, or 3Default: 3Desc

Chapter 4 - AT Commands, S-Registers, Result Codes31MultiModemDID User GuideEscape CommandsCommand: +++AT<CR> Escape SequenceValues: n/aDescri

Chapter 4 - AT Commands, S-Registers, Result Codes32MultiModemDID User GuideDID CommandsThe MT5634ZBA-DID modem uses *D commands to configure the mode

Chapter 4 - AT Commands, S-Registers, Result Codes33MultiModemDID User GuideCommand: *DT Wait for Digit Time-Out TimeValues:n = 0, 1, 2 or 3Defaul

Chapter 4 - AT Commands, S-Registers, Result Codes34MultiModemDID User GuideCommand: *DF Format for Reporting Incoming DID NumberValues: 0, 1, 2Defaul

Chapter 4 - AT Commands, S-Registers, Result Codes35MultiModemDID User Guide[15:26:52.500] DTMF9[15:26:52.500] DTMF8[15:26:52.500] DTMF0[15:27:06.610]

Chapter 4 - AT Commands, S-Registers, Result Codes36MultiModemDID User GuideS-RegistersCertain modem values, or parameters, are stored in memory locat

Chapter 4 - AT Commands, S-Registers, Result Codes37MultiModemDID User GuideS36decimal 0–7 7 Specifies the action to take in the event of anegotiation

Chapter 4 - AT Commands, S-Registers, Result Codes38MultiModemDID User Guide17 48000 bps18 49333 bps19 50666 bps20 52000 bps21 53333 bps22 54666 bps23

Chapter 4 - AT Commands, S-Registers, Result Codes39MultiModemDID User GuideResult CodesIn command mode your modem can send responses called result co

Contents4MultiModemDID User GuideChapter 6 - Troubleshooting...

Chapter 4 - AT Commands, S-Registers, Result Codes40MultiModemDID User Guide100 CONNECT 28000 *Connected at 28000 bps, 56K rate101 CONNECT 29333 *Conn

Chapter 5 - Remote Configuration41MultiModemDID User GuideChapter 5 - Remote ConfigurationRemote configuration is a network management tool that allo

Chapter 5 - Remote Configuration42MultiModemDID User GuideChanging the Remote Escape CharacterTo increase security, you can change a remote modem’s r

Chapter 6 - Troubleshooting43MultiModemDID User GuideChapter 6 - TroubleshootingYour modem was thoroughly tested at the factory before it was shipped.

Chapter 6 - Troubleshooting44MultiModemDID User GuideThe Modem Dials But Cannot ConnectThere can be several reasons the ZBA fails to make a connection

Chapter 6 - Troubleshooting45MultiModemDID User GuideThe Modem Disconnects While Online•If you have Call Waiting on the same phone line as your modem,

Chapter 6 - Troubleshooting46MultiModemDID User GuideDID Troubleshooting•Make sure that the MT5634ZBA-DID parameters match the DID line. Refer to the

Appendix A – Regulatory Compliance47MultiModemDID User GuideAppendix A – Regulatory ComplianceFCC Part 68 Telecom1. This equipment complies with part

Appendix A – Regulatory Compliance48MultiModemDID User GuideFCC Part 15This equipment has been tested and found to comply with the limits for a Class

Appendix B – Technical Specifications49MultiModemDID User GuideAppendix B – Technical SpecificationsYour MultiModemZBA-DID fax modem meets the followi

Chapter 1 - Introduction and Description5MultiModemDID User GuideChapter 1 - Introduction and DescriptionWelcome to the world of data communications.

Appendix C – Warranty and Service50MultiModemDID User GuideAppendix C - Warranty and Repairs Multi-Tech Systems, Inc. Warranty and Repairs PoliciesWar

Appendix C – Warranty and Service51MultiModemDID User GuideRepair Procedures for International Customers (Outside U.S.A. and Canada)Your original poin

Appendix D – Upgrading the Modem’s Firmware52MultiModemDID User GuideAppendix D - Upgrading the Modem’sFirmwareUpgrade Overview1. Identify your modem’

Appendix D – Upgrading the Modem’s Firmware53MultiModemDID User GuideStep 4: Extract the Upgrade Files1. Install the Flash Wizard utility by double-cl

Appendix E – Installng a Modem Under Linux54MultiModemDID User GuideAppendix E - Installing a Modem UnderLinuxIntroductionThis appendix explains how t

Appendix E – Installng a Modem Under Linux55MultiModemDID User GuideCalling the ISP1. On the Task Bar at the bottom of the screen, select the Gnome Fo

Appendix F – Technical Support56MultiModemDID User GuideAppendix F - Technical SupportMulti-Tech Systems, Inc. has an excellent staff of technical sup

Index57MultiModemDID User GuideIndexSymbols11-bit mode 2356K operationdigital loss when used withPBX 38disabling the auto rate 38maximum conn

Index58MultiModemDID User GuideDdata buffering 18data calling tone 36Data Calling Tone command 21Data Carrier Detect command17data compressio

Index59MultiModemDID User Guideremote configuration 41escape character 36, 42escape sequence 31remote node operation 12Removing a modem fr

Chapter 1 - Introduction and Description6MultiModemDID User GuideWe Supply• An MT5634ZBA-DID modem• A set of four self-adhesive plastic feet• A power

Chapter 2 - Installation7MultiModemDID User GuideChapter 2 - InstallationStep 1: Assemble the ModemThe only assembly required is to mount the feet on

Chapter 2 - Installation8MultiModemDID User Guide(Optional) Connect the Modem to the PhoneFor voice-only calls, plug a phone into the modem’s PHONE ja

Chapter 2 - Installation9MultiModemDID User GuideFrom Windows 2000, XP1. Click Start | Settings | Control Panel.2. Double-click the Phone and Modems i